On a warehouse briefing slide, a cart marker should reach the checkpoint and return to the dock while you explain the route. Give the marker one line motion path, then use its reversal setting.

Locate the endpoint before adding the return

Preview the marker’s rightward motion in Ulet Slides. Put the Checkpoint label where the marker reaches its far end. Put Dock next to its start. If the path lands short of the checkpoint, adjust the path or move the label before changing the timing.

A cart marker travels outward from Dock to the checkpoint along a rightward line.

Illustrated outward leg. Put the checkpoint where the marker actually reaches it.

Apply Auto-reverse to the path effect

Select the motion effect in Animation Pane. On Animations, enable Auto-reverse in the timing controls. Use no repeat for this example. With a one-second duration and no delay, allow about two seconds for the complete trip.

The timing diagram shows one second outward and one second back, ending at Dock.

Illustrated return. Allow time for both legs before the next cue.

Run the show and trigger the motion. Watch that it reaches Checkpoint, then finishes beside Dock. If it stays at the far end, reselect the motion effect and check Auto-reverse. Rehearse the next cue after the cart has returned.