Your stock lengths come in 25 mm steps. A part needs 137 mm, so 125 is too short and 150 is the first size that works.
Enter the length and stock step in the same unit
Put 137 in A2 and 25 in B2, with both columns labeled in millimeters. Use:
=CEILING.MATH(A2,B2)The result is 150 mm. If the job needs a trim allowance, add it to the required length before rounding and record it separately.

Illustrated stock selection. Choose the next size that covers the measurement.
Check an exact multiple and the next value
Try 150 mm and expect 150. Try 151 mm and expect 175. If your actual stock list skips some multiples, match against that list rather than assuming every 25 mm step is available.

Illustrated boundary test. An exact multiple stays put.



