The part to trim wraps around a display board corner. A rectangle would sweep up the mounting plate too. A short freehand mark makes it clear that the request applies to T-08 only.

Find a path outside the trim piece

Open a review copy of the PDF and zoom in until you can see the gap between T-08 and mounting plate P-14. Plan a path around the outside of T-08. You can leave the loop open where joining it would obscure the part number.

The L-shaped trim piece sits next to a separate plate, with a gap where the pointer can pass.

Illustrated display-board plan. Pick a route that leaves a gap around both labels.

Put down the ink and check the copy

Choose Comment → Draw. Press and drag along the path, then release to finish the stroke. Turn Draw off when you finish. If the stroke crosses P-14 or its label, undo it and take another pass with more space.

The saved ink follows the L-shaped trim and leaves T-08 and P-14 readable.

Illustrated result. At reading size, the recipient can still tell which part to trim.

Save and reopen the review copy. At the zoom a recipient would use to read the plan, verify that the ink still identifies T-08 and both part numbers are legible. If the recipient needs an action as well as a location, add a nearby comment such as “Trim T-08 to the marked profile.”