A flat gasket has an outside diameter of 64 mm and an opening of 40 mm. You need the area of the remaining material. Subtract the opening’s area from the area inside the outside edge.
Put 64 in B2 and 40 in C2. Keep both inputs in millimetres. Enter =PI()*((B2/2)^2-(C2/2)^2) in D2. The two radii are 32 and 20 mm.

Example measurements. Halve each diameter before squaring.
Check what was subtracted
Squaring the radii gives 1024 and 400. Subtract to get 624, then multiply by π. Expect about 1,960.35 mm². A larger result than the full outer circle signals a mistake. As a control, set the opening diameter to zero in a test copy and expect the full outer circle.

Example verification. Check the squared radii and output units.
Check that the opening diameter is smaller than the outside diameter before using the formula. Label the output with square units and apply display rounding without changing the underlying value.



