The part to trim wraps around a display board corner. A rectangle would sweep up the mounting plate too. A short freehand mark makes it clear that the request applies to T-08 only.
Find a path outside the trim piece
Open a review copy of the PDF and zoom in until you can see the gap between T-08 and mounting plate P-14. Plan a path around the outside of T-08. You can leave the loop open where joining it would obscure the part number.

Illustrated display-board plan. Pick a route that leaves a gap around both labels.
Put down the ink and check the copy
Choose Comment → Draw. Press and drag along the path, then release to finish the stroke. Turn Draw off when you finish. If the stroke crosses P-14 or its label, undo it and take another pass with more space.

Illustrated result. At reading size, the recipient can still tell which part to trim.
Save and reopen the review copy. At the zoom a recipient would use to read the plan, verify that the ink still identifies T-08 and both part numbers are legible. If the recipient needs an action as well as a location, add a nearby comment such as “Trim T-08 to the marked profile.”



