Someone opening the inspection report next week needs to identify the right door before they can find the loose plate. Give them a wide photo to locate the door and a close-up to identify the lower hinge.

Log the two views under the same location

In a DOCX table, use columns for Photo ID, Location, What the photo shows and Original filename. For the wide shot, enter P-07, East lobby door E2, whole-door view, and E2-overview-007.jpg. For the close-up, enter P-08, East lobby door E2, visible gap at lower hinge plate, and E2-hinge-008.jpg. Put “See P-07 for location” in the close-up row.

P-07 is an overview of East lobby door E2 and P-08 shows the gap at its lower hinge.

Illustrated inspection record. These drawings stand in for the photos you would take.

If you add thumbnails, keep the filenames as readable text. Keep the existing IDs if you remove a blurry image or sort the table by location. A reference to P-07 should lead to the same image after the edit.

Trace P-08 from the report to the original

Open the exported or shared DOCX and look up the filename in the P-08 row. Open that original and confirm that it shows the hinge gap. Follow the P-07 reference and confirm the door label E2 is visible in the wide photo. Run the same check on a row near the end of a longer log, where a shifted or pasted row can be easy to overlook.

The P-08 log row lists E2-hinge-008.jpg, with P-07 as its location reference.

Illustrated trace check. Open the file named in the row and compare the detail.